Siemens RUGGEDCOM ROX II User Manual page 341

RUGGEDCOM ROX II
CLI User Guide
routing isis interface name
Where:
• name is the name of the interface. If the desired interface is not available, it must be created as a VLAN.
For more information about creating a VLAN, refer to
3. Configure the following parameter(s) as required:
Parameter
ipv4-area-tag { ipv4-area-tag }
circuit-type { circuit-type }
point-to-point
passive
circuit-password { circuit-password }
circuit-authorization { circuit-authorization }
metric { metric }
csnp-interval { csnp-interval }
hello-interval { hello-interval }
hello-multiplier { hello-multiplier }
psnp-interval { psnp-interval }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Configuring an Interface
Section 5.37, "Managing
Description
Name of Area Tag to be used for IS-IS over IPv4.
Synopsis: { level-1-only, level-2-only, level-1-2 }
The IS-IS Circuit Type. Level-1 routers have neighbors only
on the same area. Level-2 (backbone) can have neighbors on
different areas. Level-1-2 can have neighbors on any areas.
Default is level-1-2.
Synopsis: true or false
Default: false
Enable or disable point-to-point network communication
Synopsis: true or false
Default: true
Whether an interface is active or passive. Passive interfaces do
not send packets to other routers and are not part of an IS-IS
area.
Synopsis: A string 1 to 254 characters long
The value to be used as a transmit password in IIH PDUs
transmitted by this Intermediate System.
Synopsis: { clear, md5 }
Default: clear
The authorization type ot be associated with the transmit
password in IIH PDUs transmitted by this Intermediate System.
Synopsis: An integer between 1 and 16777214
Default: 10
Metric assigned to the link, used to calculate the cost of the route.
Value ranges from 1 to 16777214. Default is 10.
Synopsis: An integer between 1 and 600
Default: 10
CSNP interval in seconds, ranging from 1 to 600. Default is 10.
Synopsis: An integer between 1 and 600
Default: 3
Hello interval in seconds, ranging from 1 to 600. Default is 3.
Synopsis: An integer between 2 and 100
Default: 10
Multiplier for Hello holding time. Value ranges from 2 to 100.
Default is 10.
Synopsis: An integer between 1 and 120
Default: 2
PSNP interval in seconds, ranging from 1 to 120. Default is 2.
Chapter 5
Setup and Configuration
VLANs".
303