Configuring Qos Marking - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
source { source }
destination { destination }
protocol { protocol }
destination-ports { destination-ports }
source-ports { source-ports }
test { test }
length { length }
tos { tos }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.39.6.3

Configuring QoS Marking

Quality of Service (QoS) marking applies a mark to important data packets that should receive preferential
treatment as they travel through the network. Only one QoS mark is allowed for each traffic control rule. Options
include:
• Set: Determines whether the packet or the connection is assigned the QoS mark.
• Modify: Changes the QoS mark value using an AND or OR argument.
Configuring QoS Marking
Description
Internet protocol type - use both when no addresses are used, otherwise define IPv4
and IPv6 rules for each type of addresses used.
Synopsis: A string
IF name, comma-separated list of hosts or IPs, MAC addresses, or 'all'.
When using MAC addresses, use '~' as prefix and '-' as separator. Ex.:
~00-1a-6b-4a-72-34,~00-1a-6b-4a-71-42
Synopsis: A string
IF name, comma-separated list of hosts or IPs, or 'all'.
Synopsis: { tcp, udp, icmp, all } or a string
Default: all
The protocol to match.
Synopsis: A string
(Optional) A comma-separated list of port names, port numbers or port ranges.
Synopsis: A string
(Optional) A comma- separated list of port names, port numbers or port ranges.
Synopsis: A string
(Optional) Defines a test on the existing packet or connection mark. The default is a
packet mark. For testing a connection mark, add ':C' at the end of the test value. Ex.:
Test if the packet mark is not zero: <emphasis role="bold">!0</emphasis> Test if the
connection mark is not zero: <emphasis role="bold">!0:C</emphasis>
Synopsis: A string
(Optional) Matches the length of a packet against a specific value or range of
values... Greater than and lesser than, as well as ranges are supported in the form
of min:max. Ex.: Equal to 64 <emphasis role="bold">64</emphasis> Greater or
equal to 65 <emphasis role="bold">65:</emphasis> Lesser or equal to 65 <emphasis
role="bold">:65</emphasis> In-between 64 and 768 <emphasis role="bold">64:768</
emphasis>
Synopsis: { minimize-delay, maximize-throughput, maximize-reliability, minimize-cost,
normal-service } or a string
(Optional) Type of Service .
A pre-defined ToS value or a numerical value. The
numerical value is hexadecimal. Ex.: 0x38
Synopsis: A string
A description for this configuration item.
Chapter 5
Setup and Configuration
579