Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
5.
Enable the Brute Force Attack (BFA) protection system on the device. For more information, refer to
Section 5.6, "Enabling/Disabling Brute Force Attack
6.
Configure the switch and all the computers behind it to use switch.0001's IP address as the default gateway.
The default IP address is 192.168.0.2.
7.
Make sure all computers connected to the device can ping one another.
Section 5.1.2
Configuring a Basic IPv6 Network
To configure a basic IPv6 network, do the following:
1.
Connect a computer to the Fast Ethernet port (fe-cm-1) of the device and configure the computer to be on
the same subnet as the port.
2.
Configure an IPv6 address and default gateway for the computer (e.g. FDD1:9AEF:3DE4::1/24 and
FDD1:9AEF:3DE4::2).
3.
Configure the fe-cm-1 and switch.0001 interfaces on the device with IPv6 addresses.
4.
Connect one of the switched ports from any available line module to an IPv6 capable network.
5.
Configure the computers on the IPv6 network to be on the same IP subnet as switch.0001 and configure the
default gateway address.
6.
Enable the Brute Force Attack (BFA) protection system on the device. For more information, refer to
Section 5.6, "Enabling/Disabling Brute Force Attack
7.
Enable IPv6 Neighbor Discovery. For more information, refer to
Discovery".
8.
Make sure all computers connected to the device can ping one another.
Section 5.2
Configuring ICMP Control
To configure how RUGGEDCOM ROX II manages ICMP redirect messages, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to admin and configure the following parameter(s) as required:
Parameter
ignore-icmp-all
ignore-icmp-broadcast
tcp-syn-cookies
Configuring a Basic IPv6 Network
Protection".
Protection".
Section 5.40.4, "Configuring IPv6 Neighbor
Description
Synopsis: true or false
Default: false
Ignores all ICMP echo requests sent to it.
Synopsis: true or false
Default: true
Ignores all ICMP ECHO and TIMESTAMP requests sent to it via
broadcast/multicast.
Synopsis: true or false
Default: false
Chapter 5
Setup and Configuration
193
Advertisement
Table of Contents
Troubleshooting
