Managing Remote Hosts; Viewing A List Of Remote Hosts; Adding A Remote Host - Siemens RUGGEDCOM ROX II User Manual

Chapter 3
Device Management
Section 3.20.9

Managing Remote Hosts

Remote hosts are required when the UDP transport connection protocol is selected for the raw socket protocol.
The following sections describe how to configure and manage remote hosts:
• Section 3.20.9.1, "Viewing a List of Remote Hosts"
• Section 3.20.9.2, "Adding a Remote Host"
• Section 3.20.9.3, "Deleting a Remote Host"
Section 3.20.9.1

Viewing a List of Remote Hosts

To view a list of remote hosts configured for a serial port using the raw socket protocol, type:
show running-config interface serial protocols rawsocket setrawsocket remote-host
If hosts have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface serial protocols rawsocket setrawsocket remote-host
interface
serial lm3 1
protocols rawsocket
setrawsocket remote-host 172.30.151.11 62011
!
setrawsocket remote-host 172.30.151.22 63000
!
!
!
!
If no remote hosts have been configured, add hosts as needed. For more information, refer to
"Adding a Remote Host".
Section 3.20.9.2

Adding a Remote Host

To add a remote host for a serial port using the raw socket protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the remote host by typing:
interface serial slot port protocols rawsocket setrawsocket remote-host address remote-port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• address is the IP address for the remote host
• remote-port is the port number for the remote host
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
120
RUGGEDCOM ROX II
CLI User Guide
Section 3.20.9.2,
Managing Remote Hosts