Siemens SINUMERIK 840D Series Diagnostics Manual page 153

11.02
Reactions:
Remedy:
Program Continuation:
12660
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12661
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12700
Parameters:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
The axis identifiers are defined via machine data 20060 AXCONF_GEOAX_NAME_TAB
and 20080 AXCONF_CHANAX_NAME_TAB. Example: C is the 4th channel axis in chan-
nel 1 and the 5th channel axis in channel 2.
If the axis identifier C is used in a cycle that is preprocessed at Power On, then this alarm
is issued.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Please inform the authorized personnel/service department.
1. Modify machine data: Select the same identifiers for geometry and channel axes in all
channels. Example: The geometry axes are called X, Y, Z in all channels. They can then
also be programmed directly in preprocessed channels.
2. Do not program the axis directly in the cycle but define it as a parameter of the axis
type. Example: Cycle definition:
PROC DRILL(AXIS DRILLAXIS) G1 AX[DRILLAXIS]=10 F1000 M17
Call from the main program:
DRILL(Z)
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 motion synchronous action: variable %3 reserved for motion
synchronous actions and technology cycles
%1 = Channel number
%2 = Block number
%3 = Variable name
The displayed variable may only be used in motion synchronous actions or in technology
cycles. For example, '$R1' may only be used in motion synchronous actions. In standard
part programs R parameters are programmed with R1.
- Alarm display.
- Interface signals are set.
- Correction block
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 technology cycle %3: no further subprogram call possible
%1 = Channel number
%2 = Block number
%3 = Name of the technology cycle call
In a technology cycle it is not possible to call a subroutine or another technology cycle.
- Alarm display.
- Interface signals are set.
- Correction block
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 contour definition programming not allowed as modal sub-
program is active
%1 = Channel number
%2 = Block number, label
1 Alarms
1-153