Siemens SINUMERIK 840D Series Diagnostics Manual page 259

11.02
17189
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17190
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17191
Parameters:
Definitions:
Reactions:
Remedy:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 D number %2 of tools defined on magazine/location %3 and %4
%1 = Channel number
%2 = Offset number D
%3 = Magazine/location number of first tool, '/' as separator
%4 = Magazine/location number of second tool, '/' as separator
The specified D number %2 in the TO unit of channel %1 is not unique. The specified T
numbers %3 and %4 each have an offset with number %2.
If tool management is active:
The specified T numbers belong to tool groups with different names.
- Alarm display.
- Interface signals are set.
1. Ensure that the D numbers within the TO unit are unique, e.g. by renaming the D num-
bers.
2. If unique numbering is not necessary for subsequent operations, do not use the com-
mand.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 illegal T number
%1 = Channel number
%2 = Block number, label
In the displayed block, access is made to a T number (tool number) that is not initialized
and therefore not available.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Check tool call in the NC part program:
• Correct tool number T.. programmed?
• Tool parameters P1 - P25 defined? The dimensions of the tool edge must have been
entered previously either through the operator panel or through the V.24 interface.
Description of the system variables $P_DP x [n, m]
n ... Associated tool number T
m ... Tool edge number D
x ... Parameter number P
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 T= %3 not existing, program %4
%1 = Channel number
%2 = Block number, label
%3 = T number or T identifier
%4 = Program name
A tool identifier which the NCK does not recognize was programmed.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
If the program pointer is at an NC block which contains the specified T identifier: If the pro-
gram is incorrect, remedy the error with a correction block and continue the program. If
the data block is missing, create one. You can do this by downloading a data block with all
the defined D numbers onto the NCK (via MMC with overstore) and continue the program.
If the program pointer is at an NC block which does not contain the specified T identifier:
The error occurred at an earlier point in the program where the T command appeared, but
the alarm was not output until the change command was detected.
1 Alarms
1-259