1 Alarms
No. 35
Explanation
Not allowed if
Remedy
No. 36
Explanation
Not allowed if
Remedy
No. 37
Explanation
Not allowed if
Remedy
No. 38
Explanation
Not allowed if
Remedy
No. 39
Explanation
Not allowed if
Remedy
No. 40
Explanation
Not allowed if
Remedy
No. 41
Explanation
Not allowed if
Remedy
No. 42
Explanation
Not allowed if
Remedy
No. 43
Explanation
Not allowed if
Remedy
No. 44
Explanation
Not allowed if
Remedy
1-580
Start machine data processing (INI file is already in the NCK). (PI command)
-
-
Start machine data processing (INI file is external, e.g.: on MMC) (PI command)
-
-
Stop because of mode group single block. VDI signal, single type A (only executable
blocks), after stop in another channel in this mode group
-
-
Stop because of mode group single block. VDI signal, single type B (any blocks), after
stop at block end in another channel in this mode group
-
-
Stop because end of overstore buffer "_N_OSTOREXX_SYF" has been reached.
-
-
Start preprocessing (NC block: Stopre)
-
-
Stop processing at block end. (NC block: M00/M01)
-
-
Stop processing at block end. (Alarm, VDI signal: NC stop at block end)
-
-
Stop at end of asynchronous subroutine, if start was performed from "stopped".
-
-
Activate program. (PI command)
-
-
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02