Siemens SINUMERIK 840D Series Diagnostics Manual page 592

1 Alarms
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
1-592
0015H
-
Version 4.0 and higher: segment of the code/data range containing the error, whereby:
0: P: memory
1: X: memory
2: Y: memory
A difference has been detected between the setpoint and actual checksums during con-
tinuous testing of the checksum.
The cause is probably a hardware error on the control module.
Replace the control module.
0016H
-
-
An illegal processor interrupt has occurred.
The cause is probably a hardware error on the control module.
Check the drive bus cable and cable connections. Replace the control module.
0017H
-
-
A disallowed processor interrupt has occurred.
The cause is probably a hardware error on the control module.
Check the drive bus cable and cable connections. Replace the control module.
0018H
-
-
An illegal processor interrupt has occurred.
The cause is probably a hardware error on the control module.
Check the drive bus cable and cable connections. Replace the control module.
0019H
-
-
An illegal processor interrupt has occurred.
The cause is probably a hardware error on the control module.
Check the drive bus cable and cable connections. Replace the control module.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02