Siemens SINUMERIK 840D Series Diagnostics Manual page 596

1 Alarms
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
1-596
0033H
0x51 ;Incorrect data format in element list
0x52 ;Incorrect conversion group specified in Refresh
-
The drive software is no longer consistent. The cause is probably a hardware error on the
control module.
Reload drive software. Replace the control module.
0034H
0 or incorrect address
0x60 ;Illegal SERVO response on STF handshake
0x61 ;Error during RAM check
0x62 ;Transport checksum does not correspond to that of the SERVO.
Errors were detected on loading the drive software. The cause is either faults during the
transfer via the drive bus or a defective control module.
Check the drive bus cable and cable connections, perform remedial measures (check
shielding or ground connection), replace control module.
0035H
0 or incorrect address
0x60 ;Illegal SERVO response on STF handshake
0x61 ;Error during RAM check
0x62 ;Transport checksum does not correspond to that of the SERVO.
Errors were detected on loading the drive software. The cause is either faults during the
transfer via the drive bus or a defective control module.
Check the drive bus cable and cable connections, perform remedial measures (check
shielding or ground connection), replace control module.
0040H
-
-
An illegal number of current setpoint filters (> 4) has been entered.
Correct number of current setpoint filters (MD 1200)
0041H
-
-
An illegal number of speed setpoint filters (> 2) has been entered.
Correct the number of speed setpoint filters (MD 1500)
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02