1 Alarms
No. 109
Explanation
Not allowed if
Remedy
No. 115
Explanation
Not allowed if
Remedy
No. 116
Explanation
Not allowed if
Remedy
No. 117
Explanation
Not allowed if
Remedy
No. 118
Explanation
Not allowed if
Remedy
1-588
Power Off: Axis is now controlled by the PLC (VDI signal)
The axis is not controlled by the PLC. Not for all axis types at present.
-
The event if triggered by the positive PLC edge of the signal "Repos-Mode-Edge".
The channel is active (program running, block search, loading machine data)
> Abort the program with the Reset key or stop the program (not with block search, load-
ing machine data)
Activate tool management commands. (Ch. VDI signal)
The NCK channel state is not ready
> Abort the program or process with the Reset key or wait for end of program.
Deactivate tool management commands. (Ch. VDI signal)
The NCK channel state is not ready
> Abort the program or process with the Reset key or wait for end of program.
Selection of desired safety limitations (SGE) (always allowed)
-
-
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02