Siemens SINUMERIK 840D Series Diagnostics Manual page 96

1 Alarms
Remedy:
Program Continuation:
10748
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10750
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10751
Parameters:
Definitions:
1-96
Modify part program. The following changes are possible:
• Indicate end point in the machining plane in the WAB block.
• Activate tool radius compensation (effective for G140 only, not for G143).
• State retraction side explicitly with G141 or G142.
• Perform retraction with a straight line instead of a circle.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal retract plane with WAB
%1 = Channel number
%2 = Block number, label
By means of DISRP a position of the retraction plane has been programmed which is not
situated between the safety distance (DISCL) and the starting point (during approach)
and/or end point (during retraction) of the WAB movement.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool radius compensation activated without tool number
%1 = Channel number
%2 = Block number, label
A tool T... must be selected so that the control can make allowance for the associated
compensation values.
A correction data block (D1) containing the correction values (parameter P1 - P25) is
automatically assigned to each tool (T number).
Up to 9 correction data blocks can be assigned to a tool by specifying the required data
block with the D number (D1 - D9).
The cutter radius compensation (CRC) is allowed for if function G41 or G42 is pro-
grammed. The correction values are contained in parameter P6 (geometry value) and
P15 (wear value) of the active correction data block Dx.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- Interpreter stop
Before calling the CRC with G41/G42, program a tool number under the address T...
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 danger of collision due to tool radius compensation
%1 = Channel number
%2 = Block number, label
The "Bottleneck detection" (calculation of intersection for the following compensated tra-
versing blocks) has not been able to calculate a point of intersection for the reviewed
number of traversing blocks. It is therefore possible that one of the equidistant paths vio-
lates the workpiece contour.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02