Siemens SINUMERIK 840D Series Diagnostics Manual page 381

11.02
Reactions:
Remedy:
Program Continuation:
61108
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61109
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61110
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61111
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify drilling depth.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 illegal values for parameters _RAD1 and _DP1
%1 = Channel number
%2 = Block number, label
The parameters _RAD1 and _DP for defining the path for the depth infeed have been
incorrectly specified. Alarm triggered by following cycles: POCKET3, POCKET4.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify parameter.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 parameter _CDIR incorrectly defined
%1 = Channel number
%2 = Block number, label
The value of the parameter for the cutting direction _CDIR has been incorrectly defined.
Alarm triggered by following cycles: POCKET3, POCKET4.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify parameter.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 finishing allowance at the base > depth infeed
%1 = Channel number
%2 = Block number, label
The finishing allowance at the base has been specified greater than the maximum depth
infeed. Alarm triggered by following cycles: POCKET3, POCKET4.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Either reduce finishing allowance or increase depth infeed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 infeed width > tool diameter
%1 = Channel number
%2 = Block number, label
The programmed infeed width is greater than the diameter of the active tool. Alarm trig-
gered by following cycles: CYCLE71, POCKET3, POCKET4.
1 Alarms
1-381