Siemens SINUMERIK 840D Series Diagnostics Manual page 252

1 Alarms
Reactions:
Remedy:
Program Continuation:
17010
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17020
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17030
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-252
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department.
• Modify machine data
• Modify the NC program, i.e. reduce the number of items related to the variable which
caused the error condition.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 no memory left
%1 = Channel number
%2 = Block number, label
When executing/reading files from the active working memory, it was found that there is
not enough memory space (e.g. for large multidimensional arrays or when creating tool
offset memory).
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Please inform the authorized personnel/service department. Make arrays smaller or make
more memory space available for memory management of subroutine calls, tool offsets
and user variables (machine data MM_...).
See /FB/, S7 Memory Configuration
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 illegal array index 1
%1 = Channel number
%2 = Block number, label
A read or write access has been programmed to an array variable with invalid 1st array
index. The valid array indices must be contained within the defined array size and the
absolute limits (0 - 32 766).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the specification of array elements in the access instruction to match the defined
size.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal array index 2
%1 = Channel number
%2 = Block number, label
A read or write access has been programmed to an array variable with invalid 2nd array
index. The valid array indices must be contained within the defined array size and the
absolute limits (0 - 32 766).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the specification of array elements in the access instruction to match the defined
size.
Clear alarm with NC START or RESET key and continue the program.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02