Siemens SINUMERIK 840D Series Diagnostics Manual page 416

1 Alarms
75210
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75250
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75255
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75260
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75265
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-416
Channel %1 number of axes/axis assignment inconsistent
%1 = Channel number
The number of axes specified in MD TRAFO 6_NUM_AXES and the number of axes
specified in MD TRAFO_AXES_ IN_1 is inconsistent or the assignment of axis in MD
TRAFO_AXES_IN_1 is incorrect. This alarm is output if the transformation is selected via
TRAORI.
- Interpreter stop
- NC Start disable in this channel.
Configure machine data.
Clear alarm with the RESET key. Restart part program
Channel %1 tool parameters incorrect
%1 = Channel number
The tool parameters are not the same as the settings for the handling transformation
package (checked in interpreter).
- Interpreter stop
- NC Start disable in this channel.
Configure machine data.
Clear alarm with the Delete key or NC START.
Channel %1 working area error
%1 = Channel number
The programmed point is not within the working range of the kinematic (checked in inter-
preter).
- Interpreter stop
Correct position.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 tool parameters incorrect
%1 = Channel number
%2 = Block number, label
The tool parameters are not the same as the settings for the handling transformation
package (checked during preprocessing run).
- Alarm display.
Correct tool parameters.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 working area error
%1 = Channel number
%2 = Block number, label
The programmed point is not within the working range of the kinematic (checked during
preprocessing run).
- Interpreter stop
- NC Start disable in this channel.
Correct position.
Clear alarm with the RESET key. Restart part program
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02