Siemens SINUMERIK 840D Series Diagnostics Manual page 444

1 Alarms
111004
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111005
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111006
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111007
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111008
Definitions:
Reactions:
Remedy:
Program Continuation:
111009
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-444
File faulty or not available: %1
%1 = File/Contour name
Easystep sequencer cannot interpret a step with contour programming.
Contour not in the directory.
- Alarm display.
Load contour into the directory.
Internal
Error when interpreting the contour %1
%1 = Contour name
Contour is faulty.
- Alarm display.
Check the contour's machining sequence.
Internal
Maximum number of contour elements exceeded %1
%1 = Contour name
The maximum permissible number of 50 contour elements was exceeded when interpret-
ing the machining sequence of a contour.
- Alarm display.
Check the contour's machining sequence and, if necessary, edit it.
Internal
Error in line %1 %2
%1 = Line number
%2 = Error description
-
- NC Start disable in this channel.
- Alarm display.
Eliminate the corresponding error.
Internal
Spindle not synchronized
Spindle not synchronized.
- Alarm display.
Let the spindle run at least one revolution (M3, M4).
Internal
Load new tool: T%1
%1 = Tool number
Tool change program requests a new tool.
- Alarm display.
- NC Stop on alarm.
Load new tool.
Internal
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02