Siemens SINUMERIK 840D Series Diagnostics Manual page 221

11.02
Reactions:
Remedy:
Program Continuation:
16105
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16110
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department. Check the part program to
determine whether the programmed spindle number is correct and whether the program
is run in the correct channel.
Check MD 35000 SPIND_ASSIGN_TO MACHAX for all machine axes to see whether
one of them contains the programmed spindle number. This machine axis number must
be entered in a channel axis of the channel-specific machine data 20070
AXCONF_MACHAX_USED.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 spindle %3 cannot be assigned
%1 = Channel number
%2 = Block number, label
%3 = String
Mistake in programming: The programmed spindle is not assigned a real axis by the spin-
dle number converter. The alarm can be issued after improper use of
$SC_SPIND_ASSIGN_TAB[].
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Correct setting data or modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 spindle %3 for dwell time not in control mode
%1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
The spindle can be in the positioning mode, oscillating mode and control mode. With the
M command M70 it can be changed from a spindle to an axis. The control mode is divided
into the speed-controlled and position-controlled mode, and it is possible to alternate
between these with the keywords SPCON and SPCOF.
Positioning mode:
Position control (spindle position under SPOS/SPOSA)
Oscillating mode:
Speed control (M41 - M45 or M40 and S...)
Control mode:
Speed control (spindle speed under S..., M3/M4/M5)
Position control (SPCON/SPCOF, spindle speed under S..., M3/M4/M5)
Axis mode:
Position control (M70/M3, M4, M5, axis position under user-selectable axis name)
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Check part program for correct spindle number.
With M3, M4 or M5 put the required spindle into control mode before calling the dwell
time.
Clear alarm with NC START or RESET key and continue the program.
1 Alarms
1-221