Siemens SINUMERIK 840D Series Diagnostics Manual page 429

11.02
101206
Definitions:
Reactions:
Remedy:
Program Continuation:
101207
Definitions:
Reactions:
Remedy:
Program Continuation:
101208
Definitions:
Reactions:
Remedy:
Program Continuation:
101209
Definitions:
Reactions:
Remedy:
Program Continuation:
101210
Definitions:
Reactions:
Remedy:
Program Continuation:
101211
Definitions:
Reactions:
Remedy:
Program Continuation:
101212
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Search action running, pleas wait
The search function was initiated in the machine data images.
- -
-
Internal
Position at $MN_
A list image, e.g. general machine data, was selected.
The MMC100 attempts to position at the datum selected last in this image.
- -
-
Internal
SI data confirmed: Axis 1
In the start-up area the function "Confirm Safety Integrated Data" has been started.
The message was output during this function in order to provided the user with an
acknowledgement regarding the operation of the function.
- -
-
Internal
SI data confirmed: Drive 1
In the start-up area the function "Confirm Safety Integrated Data" has been started.
The message was output during this function in order to provided the user with an
acknowledgement regarding the operation of the function.
- -
-
Internal
The machine data is being prepared for display
A list image in the machine data was selected for which display options are active.
This image's machine data is individually checked to see whether it is permitted to be dis-
played.
- -
-
Internal
NCK address not changed!
An attempt was made to change the bus address of the NCK in the start-up area.
The change was rejected by the NCK; the reason is unknown.
- -
-
Internal
NCK address changed!
The NCK's bus address was set to the specified value.
- -
1 Alarms
1-429