Siemens SINUMERIK 840D Series Diagnostics Manual page 54

1 Alarms
4338
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4340
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4341
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-54
Channel %1 invalid transformation type '%2' in toolholder %3 for orientation trans-
former %4
%1 = Channel number
%2 = Transformer type
%3 = Number of the orientable toolholder
%4 = Number of the orientation transformation that is to be parameterized with the orient-
able toolholder
The parameters of the orientation transformation are taken over from the data of an ori-
entable toolholder. This orientable toolholder contains an invalid transformation type.
(Types T, P and M are permissible).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Enter a valid transformation type.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 invalid transformation type in transformation no. %3
%1 = Channel number
%2 = Block number, label
%3 = Transformation number
An invalid, i.e. undefined, number was entered in one of the machine data
TRAFO_TYPE_1 ... TRAFO_TYPE_8. This alarm also occurs if a certain type of transfor-
mation is only impossible on the type of control used (e.g. 5-axis transformation on a
SINUMERIK 802D).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Enter a valid transformation type.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no data set available for transformation no. %3
%1 = Channel number
%2 = Block number, label
%3 = Transformation number
Only a limited number of machine data sets (usually 2) is available for each related group
of transformations (e.g. orientation transformations, Transmit, Tracyl, etc.). This alarm is
output if an attempt is made to set more transformations from a group.
Example:
Two orientation transformations are allowed. The machine data contains e.g.:
TRAFO_TYPE_1 = 16 ; 1st orientation transformation
TRAFO_TYPE_2 = 33 ; 2nd orientation transformation
TRAFO_TYPE_3 = 256 ; 1st transmit transformation
TRAFO_TYPE_4 = 20 ; 3rd orientation transformation ==> This entry triggers alarm
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Enter valid machine data.
Clear alarm with the RESET key. Restart part program
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02