Siemens SINUMERIK 840D Series Diagnostics Manual page 491

11.02
Reactions:
Remedy:
Program Continuation:
300704
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300705
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- NC not ready.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department.
The following values are permissible:
611D control module Current controller cycle
• Standard control as 1-axis: >= 125 µs
• Standard control as 2-axis: >= 125 µs
• Performance 1-axis: >= 62.5 µs
• Performance 2-axis: >= 125 µs
• 810D: >= 156.25 µs
• MCU: >= 125 µs
• Performance 2: >= 31.25 µs
Switch control OFF - ON.
Axis %1 drive %2 speed controller cycle time invalid
%1 = NC axis number
%2 = Drive number
An illegal value has been entered in the drive MD 1001:
$MD_SPEEDCTRL_CYCLE_TIME.
- NC not ready.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department.
The following values are permissible:
611D control module Speed controller cycle
• Standard control as 1-axis: >= 125 µs
• Standard control as 2-axis: >= 500 µs
• Performance 1-axis: >= 62.5 µs (MSD >= 125 µs)
• Performance 2-axis: >= 125 µs
• 810D: >= 312.5 µs
• MCU: >= 125 µs
• Performance 2, 1-axis: >= 31.25 µs
• Performance 2, 2-axis: >= 62.5 µs
Switch control OFF - ON.
Axis %1 drive %2 position controller cycle time invalid
%1 = NC axis number
%2 = Drive number
The monitor in the 611D module has detected a position controller pulse rate which is
beyond the permissible limits. The conditions for a permissible position controller pulse
rate are:
1 Alarms
1-491