Siemens SINUMERIK 840D Series Diagnostics Manual page 313

11.02
Remedy:
Program Continuation:
22064
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22065
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22066
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Please inform the authorized personnel/service department. Check active spindle speed
limitations. Configure a lower zero marker search velocity
$MA_REFP_VELO_SEARCH_MARKER. Check the tolerance range for the actual veloc-
ity $MA_SPIND_DES_VELO_TOL. Set a different referencing mode
$MA_ENC_REFP_MODE != 7.
Clear alarm with the RESET key. Restart part program
Channel %1 axis %2 reference point approach: zero marker search velocity (MD) is
too high
%1 = Channel number
%2 = Axis name, spindle number
The configured zero marker search velocity is too high. The encoder limit frequency is
exceeded for the active measuring system.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Configure a lower zero
marker search velocity $MA_REFP_VELO_SEARCH_MARKER. Check the encoder fre-
quency configuration $MA_ENC_FREQ_LIMIT and $MA_ENC_FREQ_LIMIT_LOW. Set
a different referencing mode ($MA_ENC_REFP_MODE != 7).
Clear alarm with the RESET key. Restart part program
Channel %1 tool management: Tool motion is not possible, as tool %2 with Duplo
no. %3 is not in magazine %4
%1 = Channel number
%2 = String (identifier)
%3 = Duplo no.
%4 = Magazine no.
The desired tool motion command - triggered from the MMC or PLC - is not possible. The
specified tool is not contained in the specified magazine. (NCK cannot contain tools that
are not assigned to a magazine. With this kind of tool, no operations (motion, change) can
be performed.)
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
Check that the specified tool is contained in the desired magazine, or program another
tool to be changed.
Clear alarm with the Delete key or NC START.
Channel %1 tool management: Tool change is not possible, as tool %2 with Duplo
no. %3 is not in magazine %4
%1 = Channel number
%2 = String (identifier)
%3 = Duplo no.
%4 = Magazine no.
The desired tool change is not possible. The specified tool is not contained in the speci-
fied magazine. (NCK cannot contain tools that are not assigned to a magazine. With this
kind of tool, no operations (motion, change) can be performed.)
1 Alarms
1-313