Siemens SINUMERIK 840D Series Diagnostics Manual page 264

1 Alarms
17250
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17260
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17262
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17270
Parameters:
Definitions:
Reactions:
1-264
Channel %1 block %2 illegal magazine definition
%1 = Channel number
%2 = Block number, label
If an attempt is made to modify a magazine data that would subsequently damage the
data consistency or lead to a conflicting definition, this alarm will appear.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal magazine location definition
%1 = Channel number
%2 = Block number, label
If an attempt is made to modify a magazine location data that would subsequently dam-
age the data consistency or lead to a conflicting definition, this alarm will appear.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal tool adapter operation
%1 = Channel number
%2 = Block number, label
If an attempt is made to define or cancel a tool adapter assignment with reference to a
magazine location and this magazine location already has another tool adapter and/or a
tool is located in the adapter or - when canceling an assignment - a tool is still at the loca-
tion, this alarm will appear. If machine data $MC_MM_NUM_SUMCORR has the value -1,
adapters cannot be generated by a write operation to an adapter which is not already
defined. While the machine data has this value, you can only write adapter data to adapt-
ers which have already been (automatically) assigned to magazine locations.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
• Assign a maximum of one adapter to a magazine location.
• The magazine location must not contain a tool.
• Machine data $MC_MM_NUM_SUMCORR has value -1: If an alarm occurs when writ-
ing one of the system parameters $TC_ADPTx (x=1,2,3,T), the write operation must be
modified such that only adapter data which are already associated with the magazine
locations are written.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 call-by-reference: illegal variable
%1 = Channel number
%2 = Block number, label
Machine data and system variables must not be transferred as call-by-reference parame-
ters.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02