Siemens SINUMERIK 840D Series Diagnostics Manual page 202

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
14800
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14810
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14811
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-202
In the NC block, an axis has been programmed that is already being traversed by the
PLC.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
• Modify part program, do not use this axis.
• Stop traversing motion of the axis by the PLC, modify part program (insert WAITP).
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 programmed path speed less or equal to zero
%1 = Channel number
%2 = Block number, label
A negative F value has been programmed in conjunction with the G functions G93, G94,
G95 or G96. The path velocity may be programmed in the range 0.001 to 999 999.999
[mm/min, mm/rev, deg/min, deg/rev] for the metric input system and 0.000 1 to 39
999.999 9 [inch/min, inch/rev] for the inch input system.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program the path velocity (geometric sum of the velocity components of the geometry
axes involved) within the limits given above.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 negative axis speed programmed for positioning axis %3
%1 = Channel number
%2 = Block number, label
%3 = Axis
A negative feed (FA value) has been programmed for the displayed axis presently operat-
ing as a positioning axis. The positioning velocity may be programmed in the range 0.001
to 999 999.999 [mm/min, deg/min] for the metric input system and 0.000 1 to 39 999.999
9 [inch/min, inch/rev] for the inch input system.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Program the positioning velocity within the limits given above.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 incorrect value range for acceleration of axis/spindle %3
%1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
A value outside of the permissible input range of the programmed acceleration has been
used. Values of between 1 and 200 % are possible.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Adjust the value range in accordance with the Programming Guide. Values of 1 ... 200%
are allowed.
Clear alarm with NC START or RESET key and continue the program.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02