Siemens SINUMERIK 840D Series Diagnostics Manual page 569

11.02
Program Continuation:
380070
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
380071
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
380072
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Clear alarm with the Delete key or NC START.
Profibus DP: no input slot available for base address %1 (length %2)
%1 = Logical base address of the requested area
%2 = Size of the area in bytes
An incorrect logical base address was specified for a digital or analog input. Either no slot
has been configured for this base address or the requested area extends beyond the end
of the slot.
Length=1 indicates a digital input.
Length=2 indicates a analog input.
- Alarm display.
- Interface signals are set.
- Channel not ready.
- NC Start disable in this channel.
Enter correct base addresses in the machine data:
• For length=1: Correct machine data MN_HW_ASSIGN_DIG_FASTIN.
• For length=2: Correct machine data MN_HW_ASSIGN_ANA_FASTIN.
• NCK restart
If the error cannot be eliminated by this procedure, please make a note of the error text
and contact the control system manufacturer.
Switch control OFF - ON.
Profibus DP: no output slot available for base address %1 (size %2)
%1 = Logical base address of the requested area
%2 = Size of the area in bytes
An incorrect logical base address was specified for a digital or analog input. Either no slot
has been configured for this base address or the requested area extends beyond the end
of the slot.
For length =1 it is a digital output,
For length =2 it is an analog output.
- Alarm display.
- Interface signals are set.
- Channel not ready.
- NC Start disable in this channel.
Enter correct base addresses in the machine data:
• For length=1: Correct machine data MN_HW_ASSIGN_DIG_FASTOUT.
• For length=2: Correct machine data MN_HW_ASSIGN_ANA_FASTOUT.
• NCK restart
If the error cannot be eliminated by this procedure, please make a note of the error text
and contact the control system manufacturer.
Switch control OFF - ON.
Profibus DP: output slot for base address %1 (size %2) not allowed
%1 = Logical base address of the requested area
%2 = Size of the area in bytes
An incorrect logical base address was set for a digital or analog output, the area is resides
in the access range of the PLC (PIQ, base addresses < 128).
For length =1 it is a digital output,
For length =2 it is an analog output.
1 Alarms
1-569