Siemens SINUMERIK 840D Series Diagnostics Manual page 585

11.02
No. 82
Explanation
Not allowed if
Remedy
No. 83
Explanation
Not allowed if
Remedy
No. 84
Explanation
Not allowed if
Remedy
No. 85
Explanation
Not allowed if
Remedy
No. 86
Explanation
Not allowed if
Remedy
No. 87
Explanation
Not allowed if
Remedy
No. 88
Explanation
Not allowed if
Remedy
No. 89
Explanation
Not allowed if
Remedy
No. 90
Explanation
Not allowed if
Remedy
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Start a program in the TEACH IN submode. (VDI-Signal: NC-Start
See 33 and 5
-
Start a program in the TEACH IN submode. (VDI signal: NC Start)
See 33 and 5
-
Reorganize block processing.
-
-
Activate user interrupt "asynchronous subroutine" in a manual mode. (VDI signal: asyn-
chronous subroutine interface, digital-analog interface)
See 10
-
Activate user interrupt "Asynchronous subroutine" Is only executed with READY channel
status (VDI signal: asynchronous subroutine interface, digital-analog interface)
See 10
-
Perform user interrupt "Asynchronous subroutine". (VDI signal: digital-analog interface
and asynchronous subroutine interface, for further actions see 10, 11, 12, 85, 86).
-
-
Stop processing. (VDI signal: mode group Stop)
-
-
Set all machine data with the attribute (NEW_CONF) active. (NC block: NEW_CONF)
-
-
Set all machine data with the attribute (NEW_CONF) active. (NC block: NEW_CONF at
block search)
-
-
1 Alarms
1-585