Siemens SINUMERIK 840D Series Diagnostics Manual page 43

11.02
Remedy:
Program Continuation:
4113
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4114
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4115
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4150
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Machine data 10060 POSCTRL_SYSCLOCK_TIME_RATIO RATIO has been modified.
Clear alarm with the RESET key. Restart part program
Sysclock cycle changed to %1 ms
%1 = String (new PLC cycle time)
MD 10050 SYSCLOCK_CYCLE_TIME has been modified on systems with PROFIBUS
DP because of the modified DP cycle in SDB1000.
- Alarm display.
Machine data 10050 SYSCLOCK_CYCLE_TIME has been modified.
Clear alarm with the RESET key. Restart part program
Error in DP cycle of SDB1000
%1 = String (new PLC cycle time)
The DP cycle in SDB1000 contains an error and cannot be set. The default value of
$MN_SYSCLOCK_CYCLE_TIME is set.
- Alarm display.
Correct SDB1000
Switch control OFF - ON.
Time ratio communication to Ipo changed to %1
%1 = String (new PLC cycle time)
The value of the machine data 10072 has been adapted. This can only occur, if the value
of the machine data is smaller than one and the time thus calculated is no multiple of the
position control cycle.
- Alarm display.
The machine data $MN_COM_IPO_TIME_RATIO has been adapted. Please check to
ensure that the calculated value is correct.
Clear alarm with the RESET key. Restart part program
Channel %1 invalid M function subprogram call configured
%1 = Channel number
The machine data $MN_M_NO_FCT_CYCLE[n] or $MN_M_NO_FCT_CYCLE_PAR con-
tains invalid configuration data: An M function, which is used by the system and can not
be replaced by a subprogram call has been specified in the machine data
$MN_M_NO_FCT_CYCLE[n] for the configuration of the subprogram call via M function:
• M0 to M5,
• M17, M30,
• M19, M40 to M45,
• M function for selecting spindle/axis mode according to
$MC_SPIND_RIGID_TAPPING_M_NR (default: M70),
• M functions for nibbling/punching as configured in $MC_NIBBLE_PUNCH_CODE if
activated by $MC_PUNCHNIB_ACTIVATION.
• Also M96 to M99 for applied external language ($MN_MM_EXTERN_LANGUAGE).
The machine data $MN_M_NO_FCT_CYCLE_PAR contains an invalid array index of
$MN_M_NO_FCT_CYCLE[n]. Currently, the values 0 to 9 are permissible. The affected
machine data is reset to the default value -1. This deactivates the function.
1 Alarms
1-43