Siemens SINUMERIK 840D Series Diagnostics Manual page 216

1 Alarms
Remedy:
Program Continuation:
15450
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15460
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15500
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15700
Parameters:
Definitions:
1-216
• Correct the INI, GUD or macro file.
• Correct part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 compiled program cannot be stored
%1 = Channel number
%2 = Block number, label
In the compile mode, a compiled program could not be stored. One of the following rea-
sons applies:
• Not enough memory
• Intermediate code line (compilate) too large
- Alarm display.
Create space in work memory or modify part program (make it less complex).
Clear alarm with the Delete key or NC START.
Channel %1 block %2 syntax error with modal function
%1 = Channel number
%2 = Block number, label
The addresses programmed in the block are not compatible with the modal syntax-deter-
mining G function.
Example:
N100 G01 ... I .. J.. K.. LF
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the displayed block and ensure that the G functions and addresses in the block
are in agreement.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal angle of shear
%1 = Channel number
%2 = Block number, label
The function CSHEAR has been called with an illegal (impossible) angle of shear, e.g.
when the sum of angles between the axis vectors is greater than 360 degrees.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Program the angle of shear in accordance with the geometrical conditions of the machine
and workpiece system.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 illegal cycle alarm number %3
%1 = Channel number
%2 = Block number, label
%3 = Cycle alarm number
A SETAL command has been programmed with a cycle alarm number less than 60 000 or
greater than 67 999.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02