Siemens SINUMERIK 840D Series Diagnostics Manual page 440

1 Alarms
Reactions:
Remedy:
Program Continuation:
105042
Definitions:
Reactions:
Remedy:
Program Continuation:
105043
Definitions:
Reactions:
Remedy:
Program Continuation:
105050
Definitions:
Reactions:
Remedy:
Program Continuation:
105051
Definitions:
Reactions:
Remedy:
Program Continuation:
105052
Definitions:
Reactions:
Remedy:
Program Continuation:
105053
Definitions:
Reactions:
Remedy:
Program Continuation:
105054
Definitions:
1-440
- -
-
Internal
Impermissible block number!
The first block number is less than 0 or greater than 999999.
- -
-
Internal
Impermissible increment!
The increment was entered as a negative.
- -
-
Internal
Please wait: Graphic is being output!
The help displays are being prepared for display.
- -
-
Internal
Output of dynamic long texts for cycle parameterization
The dynamic long texts for the cycle parameterization are output here.
- -
-
Internal
Error in the cycle description of the <xxx>!
The cycle description sc.com, uc.com contains a line that cannot be interpreted.
This line is output via <xxx>.
- -
-
Internal
No cycle available in current line!
The editor's cursor is in a line that does not contain a cycle.
A recompilation is not possible.
- -
-
Internal
Error during cycle description call!
One of the sc.com, cov.com cycle description files contains a non-interpretable parame-
ter.
IInitilization of the cycles is aborted.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02