Siemens SINUMERIK 840D Series Diagnostics Manual page 397

11.02
Remedy:
Program Continuation:
61249
Definitions:
Reactions:
Remedy:
Program Continuation:
61250
Definitions:
Reactions:
Remedy:
Program Continuation:
61251
Definitions:
Reactions:
Remedy:
Program Continuation:
61252
Definitions:
Reactions:
Remedy:
Program Continuation:
61253
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Increase infeed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Number of edges too small
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Increase number of edges.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Key width/Edge length too small
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Increase key width/edge length.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Key width/Edge length too large
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Decrease key width/edge length.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Chamfer/Radius too large
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Decrease chamfer/radius.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: No finishing allowance programmed
No finishing allowance was entered.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Program a finishing allowance.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-397