Siemens SINUMERIK 840D Series Diagnostics Manual page 83

11.02
Remedy:
Program Continuation:
10209
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10222
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10223
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10225
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10299
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Press NC Start.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 internal NC stop after block search
%1 = Channel number
Internal alarm which initiates an NC Stop. The alarm is output if
$MN_SEARCH_RUN_MODE ==1 and the last action block is activated after block search
in the main run. Alarm 10208 is activated depending on the VDI signal PLC -> NCK chan-
nel DBB1.6.
- NC Stop on alarm.
- Program execution is aborted, not effective for single axes
- Interpreter stop
NC-Start
Clear alarm with NC START or RESET key and continue the program.
Channel %1 inter-channel communication not possible
%1 = Channel number
This channel has received a negative acknowledgment from the inter-channel communi-
cation because the destination channel number is not known, e.g.: START(x) or
WAITE(x) but channel x has not been initialized
- Alarm display.
This is an indication of possible discrepancies. The program continues if no acknowledg-
ment is called for.
Clear alarm with the Delete key or NC START.
Channel %1: Command %2 is already occupied
%1 = Channel number
%2 = Event name
This channel has received a negative acknowledgment from the inter-channel communi-
cation because this command is already active or has not yet been terminated, e.g.:
INIT(x,"ncprog") but a program select request is already active for channel x.
- Alarm display.
This is an indication of possible discrepancies. The program continues if no acknowledg-
ment is called for.
Clear alarm with the Delete key or NC START.
Channel %1: command denied
%1 = Channel number
The channel has received a command. The command cannot be executed.
- Alarm display.
Press RESET.
Clear alarm with the Delete key or NC START.
Channel %1 Auto-Repos function is not enabled
%1 = Channel number
The Auto-Repos function (operating mode) was selected in the channel but is not imple-
mented.
- Alarm display.
1 Alarms
1-83