Siemens SINUMERIK 840D Series Diagnostics Manual page 16

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
1012
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1013
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1014
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-16
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the RESET key. Restart part program
Channel %1 system error %2 %3 %4
%1 = Channel number
%2 = System error number
%3 = Parameter1
%4 = Parameter2
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- Alarm display.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the Delete key or NC START.
Channel %1 system error %2
%1 = Channel number
%2 = System error number
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- Alarm display.
- Interface signals are set.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the RESET key. Restart part program
Channel %1 system error %2
%1 = Channel number
%2 = System error number
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- Alarm display.
- Interface signals are set.
- Local alarm reaction.
- Mode group not ready.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02