Siemens SINUMERIK 840D Series Diagnostics Manual page 183

11.02
Definitions:
Reactions:
Remedy:
Program Continuation:
14210
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14250
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
In the endpoint specification of a traversing block with G00, G01, G02 or G03 in polar
coordinates, the polar radius entered for the keyword RP=... is negative.
Definition of terms:
• Specification of end of block point with polar angle and polar radius, referring to the cur-
rent pole (preparatory functions: G00/G01/G02/G03).
• New definition of the pole with polar angle and pole radius, referring to the reference
point selected with the G function. G110 ... last programmed point in the plane, G111 ...
zero point of the current work, G112 ... last pole
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct NC part program - permissible inputs for the pole radius are only positive absolute
values that specify the distance between the current pole and the block end point. (The
direction is defined by the polar angle AP=...).
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 polar angle too large
%1 = Channel number
%2 = Block number, label
In specifying the endpoints in a traversing block with G00, G01, G02 or G03 in polar coor-
dinates, the value range of the polar angle programmed under the keyword AP=... has
been exceeded. It covers the range from -360 to +360 degrees with a resolution of 0.001
degrees.
Definition of terms:
• Specification of end of block point with polar angle and polar radius, referring to the cur-
rent pole (preparatory functions: G00/G01/G02/G03).
• New definition of the pole with polar angle and pole radius, referring to the reference
point selected with the G function. G110 ... referred to the last programmed point in the
plane, G111 ... referred to the zero point of the current workpiece coordinate system
(WCS), G112 ... referred to the last pole.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Correct NC part program. The permissible input range for the polar angle is between the
values -360 degrees and +360 degrees with a resolution of 0.001 degrees.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 negative pole radius
%1 = Channel number
%2 = Block number, label
In redefining the pole with G110, G111 or G112 in polar coordinates, the pole radius spec-
ified under keyword RP=... is negative. Only positive absolute values are permitted.
Definition of terms:
• Specification of end of block point with polar angle and polar radius, referring to the cur-
rent pole (preparatory functions: G00/G01/G02/G03).
• New definition of the pole with polar angle and pole radius, referring to the reference
point selected with the G function. G110 ... last programmed point in the plane, G111 ...
zero point of the current work, G112 ... last pole
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
1 Alarms
1-183