Siemens SINUMERIK 840D Series Diagnostics Manual page 237

11.02
16810
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16820
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16830
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 traverse instruction ACP for axis %3 not allowed
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The keyword ACP (Absolute Coordinate Positive) is only allowed for "modulo axes". It
causes approach of the programmed absolute position in the specified direction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department. In the displayed NC block,
replace the keyword ACP by specifying AC (Absolute Coordinate).
If the alarm display is based on an incorrect axis definition, the axis with the axis-specific
MD 30300: IS_ROT_AX and MD 30310: ROT_IS_MODULO can be declared a rotary axis
with modulo change.
Corresponding machine data:
Modify MD 30,320: DISPLAY_IS_MODULO
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 traverse instruction ACN for axis %3 not allowed
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The keyword ACN (Absolute Coordinate Negative) is only allowed for "modulo axes". It
causes approach of the programmed absolute position in the specified direction.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Please inform the authorized personnel/service department. In the displayed NC block,
replace the keyword ACN by specifying AC (Absolute Coordinate).
If the alarm display is based on an incorrect axis definition, the axis with the axis-specific
MD 30300: IS_ROT_AX and MD 30310: ROT_IS_MODULO can be declared a rotary axis
with modulo change.
Corresponding machine data:
Modify MD 30320: DISPLAY_IS_MODULO
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 incorrect position programmed for axis/spindle %3
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A position beyond the range of 0 - 359.999 has been programmed for a modulo axis.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Program position in the range 0 - 359.999.
Clear alarm with NC START or RESET key and continue the program.
1 Alarms
1-237