Siemens SINUMERIK 840D Series Diagnostics Manual page 430

1 Alarms
Remedy:
Program Continuation:
101213
Definitions:
Reactions:
Remedy:
Program Continuation:
101214
Definitions:
Reactions:
Remedy:
Program Continuation:
101300
Definitions:
Reactions:
Remedy:
Program Continuation:
103000
Definitions:
Reactions:
Remedy:
Program Continuation:
103001
Definitions:
Reactions:
Remedy:
Program Continuation:
103002
Definitions:
Reactions:
1-430
-
Internal
Invalid NCK address.
The value specified for the new NCK bus address is too large.
- -
-
Internal
Initialization of this window failed!
An attempt was made to select the image of the NCK address in the start-up area.
An error occured while determining the nodes on the bus.
Due to inconsistent data, this image cannot be displayed.
- -
-
Internal
Please wait - language is being changed
In the start-up area the soft key "Change language" was pressed.
The screen content is being restructured.
- -
-
Internal
There is no correction block on the NCK
The following is valid up to SW 3.x: The correction block window cannot be opened. No
program correction is possible in the operating mode "Machine".
The following is valid up to SW 4.1: The correction block window can be opened in the
"Stop program" state.
The edit program that is currently being executed is opened.
The program part that has not yet been recorded by the NCK's program processing can
be changed permanently.
- -
-
Internal
Selection is only possible after being enabled or in the RESET state.
In order to execute the desired function, the current channel has to be in the RESET
state, e.g. "Program selection".
- -
Trigger reset.
Internal
Copying to the clipboard is not possible
The NCK rejects a copy-action to the clipboard because, for example, no more memory is
available or the maximum manageable amount of programs has been exceeded.
- -
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02