Siemens SINUMERIK 840D Series Diagnostics Manual page 90

1 Alarms
Reactions:
Remedy:
Program Continuation:
10701
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10702
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10703
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10704
Parameters:
1-90
- Alarm display.
- Interface signals are set.
- Local alarm reaction.
- NC Stop on alarm.
Protection zone can be traversed after a new NC Start.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 channel-specific protection zone %3 violated during auto-
matic or MDA mode
%1 = Channel number
%2 = Block number
%3 = Protection zone number
The workpiece-related channel-specific protection zone has been violated. Note that
another tool-related protection zone is still active. The workpiece-related protected area
can be traversed after a new NC Start.
- Alarm display.
- Interface signals are set.
- Local alarm reaction.
- NC Stop on alarm.
Protection zone can be traversed after a new NC Start.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 NCK protection zone %2 violated during manual mode
%1 = Channel number
%2 = Protection zone number
The workpiece-related NCK protection zone has been violated. Note that another tool-
related protection zone is still active. The workpiece-related protected area can be tra-
versed after a new NC Start.
- Alarm display.
- Interface signals are set.
- Local alarm reaction.
Protection zone can be traversed after a new NC Start.
Alarm display showing cause of alarm disappears. No further operator action
Channel %1 channel-specific protection zone %2 violated during manual mode
%1 = Channel number
%2 = Protection zone number
The workpiece-related channel-specific protection zone has been violated. Note that
another tool-related protection zone is still active. The workpiece-related protected area
can be traversed after a new NC Start.
- Alarm display.
- Interface signals are set.
- Local alarm reaction.
Protection zone can be traversed after a new NC Start.
Alarm display showing cause of alarm disappears. No further operator action
Channel %1 block %2 protection zone monitoring is not guaranteed
%1 = Channel number
%2 = Block number, label
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02