Siemens SINUMERIK 840D Series Diagnostics Manual page 93

11.02
10730
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10731
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10740
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10741
Parameters:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %3 axis %2 working area limitation %4
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
%4 = String ( + or - )
This alarm is generated if it is determined during block preparation that the programmed
path of the axis will result in exceeding the working area limitation.
- Alarm display.
- Interface signals are set.
- Local alarm reaction.
- Correction block is reorganized.
a) Check NC program for correct positional data and, if necessary, make corrections.
b) Check zero offsets (current frame)
c) Correct working area limitation via G25, or
d) Correct working area limitation via setting data, or
e) Deactivate working area limitation via setting data 43410
WORKAREA_MINUS_ENABLE=FALSE
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %3 axis %2 working area limitation %4
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
%4 = String ( + or - )
For the axis, the planned motion violates the working area limit. The alarm is activated
during the preparation of approach or rest blocks at REPOS.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Abort part program with reset.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 too many empty blocks in WAB programming
%1 = Channel number
%2 = Block number, label
It is not allowed to program more blocks than specified by machine data
MC_WAB_MAXNUM_DUMMY_BLOCKS between the WAB block and the block deter-
mining the approach and retraction tangent.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 direction reversal with WAB infeed motion
%1 = Channel number
%2 = Block number, label
1 Alarms
1-93