Siemens SINUMERIK 840D Series Diagnostics Manual page 468

1 Alarms
Program Continuation:
300011
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300012
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300020
Parameters:
Definitions:
Reactions:
Remedy:
1-468
It might be necessary to first declare an NC axis in the channel for this drive (MD 20070
AXCONF_MACHAX_USED = K, [K ...channel axis no.]).
Switch control OFF - ON.
Axis %1 drive %2 hardware version of spindle not supported
%1 = NC axis number
%2 = Drive number
An old spindle power section (so-called 186-HSA) is connected to the drive bus. This
spindle drive is not supported by SINUMERIK 840D. Ramp-up is interrupted.
- NC not ready.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. A DSP spindle module must
be ordered and fitted.
Switch control OFF - ON.
Axis %1 drive %2 hardware version of control module not supported
%1 = NC axis number
%2 = Drive number
There is a drive module with an "old" control module on the drive bus. 810D does not sup-
port these modules. Ramp-up is interrupted.
- NC not ready.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. Order standard or perfor-
mance control module and exchange with "old".
Switch control OFF - ON.
Drive %1 removed for diagnosis
%1 = Drive number
The alarm indicates that the drive bus configuration has been changed temporarily. The
alarm is output if MD 13030 $MN_DRIVE_MODULE_TYPE has value 0 (zero) when a
drive is configured.
- Mode group not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
- Alarm display.
- Interface signals are set.
• Normal operation (full bus configuration): Integrate drive module into the bus again,
enter the correct type in MD 13030 $MN_DRIVE_MODULE_TYPE.
• Normal operation (module remains removed): Remove the module in the configuration
screen. Remove all connections to outputs and inputs.
• MD30110 $MA_CTRLOUT_MODULE_NR
• MD30130 $MA_CTRLOUT_TYPE
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02