Siemens SINUMERIK 840D Series Diagnostics Manual page 227

11.02
Reactions:
Remedy:
Program Continuation:
16715
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16720
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16730
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Add S value or direction of rotation for the master spindle in the displayed block.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 axis %3 spindle not in standstill
%1 = Channel number
%2 = Block number, label
%3 = Spindle number
In the applied function (G74, reference point approach), the spindle must be stationary.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Program M5 or SPOS/SPOSA in front of the defective block in the part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 thread lead is zero
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
No lead was programmed in a thread block with G33 (thread with constant lead) or G331
(rigid tapping).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
The thread lead must be programmed for the specified geometry axis under the associ-
ated interpolation parameters.
X -> I
Y -> J
Z -> K
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 wrong parameter
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
In G33 (tapping with constant lead) the lead parameter was not assigned to the axis that
determines the velocity.
For longitudinal and face threads, the thread lead for the specified geometry axis must be
programmed under the associated interpolation parameter.
X -> I
Y -> J
Z -> K
For taper threads, the address I, J, K depends on the axis with the longer path (thread
length). A 2nd lead for the other axis is, however, not specified.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
1 Alarms
1-227