Siemens SINUMERIK 840D Series Diagnostics Manual page 88

1 Alarms
Reactions:
Remedy:
Program Continuation:
10652
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10653
Parameters:
Definitions:
Reactions:
1-88
• %2 = 3000 => different contents in MD 30550 slave axis and master axis
• %2 = 10000 => error: slave axis is geometry axis
• %2 = 11000 => error: competing position axis as slave axis
• %2 = 12000 => error: compile cycle axis as slave axis
• %2 = 13000 => error: gantry axis is spindle
• %2 = 14000 => error: gantry axis is Hirth geared
e.g. error no. 1001 = no master axis declared, grouping 1.
- Alarm display.
- Interface signals are set.
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Correct the machine data:
MD 37100 GANTRY_AXIS_TYPE
0: No gantry axis
1: Master axis grouping 1
11: Slave axis grouping 1
2: Master axis grouping 2
12: Slave axis grouping 2
3: Master axis grouping 3
13: Slave axis grouping 3
Switch control OFF - ON.
Channel %1 axis %2 gantry warning threshold exceeded
%1 = Channel number
%2 = Axis
The gantry following axis has exceeded the warning limit specified in MD 37110
GANTRY_POS_TOL_WARNING.
- Alarm display.
Please inform the authorized personnel/service department.
1. Check axis (uneven mechanical movement?)
2. MD not set correctly (MD 37110 GANTRY_POS_TOL_WARNING). Changes to this
MD take effect after a RESET.
Alarm display showing cause of alarm disappears. No further operator action
Channel %1 axis %2 gantry error threshold exceeded
%1 = Channel number
%2 = Axis
The gantry following axis has exceeded the error limit (actual value tolerance) specified in
MD 37120 GANTRY_POS_TOL_ERROR.
- NC Start disable in this channel.
- Alarm display.
- Interface signals are set.
- NC Stop on alarm.
- If the axis is a single axis when this alarm is triggered, the alarm is only effective for this
axis (not effective for e.g. the channel or mode group)
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02