Siemens SINUMERIK 840D Series Diagnostics Manual page 454

1 Alarms
112301
Definitions:
Reactions:
Remedy:
Program Continuation:
112323
Definitions:
Reactions:
Remedy:
Program Continuation:
112324
Definitions:
Reactions:
Remedy:
Program Continuation:
112325
Definitions:
Reactions:
Remedy:
Program Continuation:
112326
Definitions:
Reactions:
Remedy:
Program Continuation:
112327
Definitions:
Reactions:
Remedy:
Program Continuation:
112328
Definitions:
Reactions:
1-454
Tool management type 2 not possible. The magazine is not sorted as in the tool list.
The magazine list sorting does not correspond to that of the tool list.
In the magazine of tool management type 2, the sequence of the tools has to be defined
according to their T numbers.
- Alarm display.
Installation and start-up: Assign the tools according to their T numbers to the magazine
locations.
Internal
Replace swivel head.
The operator is prompted to remove the specified swivel head from the spindle.
- Alarm display.
Replace swivel head.
When doing this, please follow the machine manufacturer's instructions.
Internal
Load swivel head.
The operator is prompted to load the specified swivel head into the spindle.
- Alarm display.
Load swivel head.
When doing this, please follow the machine manufacturer's instructions.
Internal
Exchange swivel head.
The operator is prompted to replace the specified swivel head in the spindle with the new
swivel head.
- Alarm display.
Exchange swivel head.
When doing this, please follow the machine manufacturer's instructions.
Internal
Set swivel head
The operator is prompted to set the swivel head in accordance with the specified data.
- Alarm display.
Set swivel head.
When doing this, please follow the machine manufacturer's instructions.
Internal
Angle not in permissible area
The programmed machining cannot be carried out with the swivel head.
- Alarm display.
If necessary, clamp the workpiece differently.
Internal
Angle adapted to angle grid.
Due to the angle grid, the swivel head could not be set exactly to the specified angle.
- Alarm display.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02