Siemens SINUMERIK 840D Series Diagnostics Manual page 449

11.02
111308
Definitions:
Reactions:
Remedy:
Program Continuation:
111309
Definitions:
Reactions:
Remedy:
Program Continuation:
111310
Definitions:
Reactions:
Remedy:
Program Continuation:
111311
Definitions:
Reactions:
Remedy:
Program Continuation:
111400
Definitions:
Reactions:
Remedy:
Program Continuation:
111410
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Error when setting upper spindle speed limit
In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 111306 to 111310 occurs, these settings cannot be car-
ried out.
- Alarm display.
Perform an NCK reset
Internal
Error when selecting tool
In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 111306 to 111310 occurs, these settings cannot be car-
ried out.
- Alarm display.
Perform an NCK reset
Internal
Error when selecting zero offset
In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 11306 to 111310 occurs, these settings cannot be carried
out.
- Alarm display.
Perform an NCK reset
Internal
NC start not possible: Deselect single block
A program was activated with block search, while at the same time single block was
active.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Deselect single block.
Internal
Unknown PLC error
The PLC has announced an error that is unknown in the operator panel.
- NC Start disable in this channel.
- Alarm display.
Inform Siemens.
Switch control OFF - ON.
Tool %1 was created
%1 = Tool number
When ManualTurn is booted, a check is run to see whether all standard tools are avail-
able. If this is not the case, the missing tools will be created automatically. If several tools
are created, they will be output in an aggregate signal.
Meaning: Example: %1Number of the tool that was created, 5 %1First and last tool
that were created, 5...16.
- -
1 Alarms
1-449