1 Alarms
Remedy:
Program Continuation:
14133
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14134
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14140
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14144
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-176
Adapt machine data.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 G code for orientation definition not allowed
%1 = Channel number
%2 = Block number, label
It is only possible to program a G code of the 50th G code group if machine data
ORI_DEF_WITH_G_CODE is set to TRUE.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Adapt machine data.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 G code for orientation interpolation not allowed
%1 = Channel number
%2 = Block number, label
It is only possible to program a G code of the 51st G code group if machine data
ORI_DEF_WITH_G_CODE or ORI_IPO_WITH_G_CODE is set to TRUE.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Adapt machine data.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 position programming without transformation not allowed
%1 = Channel number
%2 = Block number, label
Position information was programmed for an axis position but no transformation was
active.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Modify the program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 PTP movement not allowed
%1 = Channel number
%2 = Block number, label
The PTP G code was programmed for a movement other than G0 or G1.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Modify the program.
Clear alarm with the RESET key. Restart part program
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02