Siemens SINUMERIK 840D Series Diagnostics Manual page 275

11.02
Remedy:
Program Continuation:
18311
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18312
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18313
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18314
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 frame: illegal instruction
%1 = Channel number
%2 = Block number, label
An attempt was made to read or write a frame which does not exist.
- Alarm display.
- Interface signals are set.
- NC Stop on alarm.
- Interpreter stop
- NC Start disable in this channel.
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 frame: fine shift not configured
%1 = Channel number
%2 = Block number, label
Fine shift must be configured with G58 and G59.
- Alarm display.
- Interface signals are set.
- NC Stop on alarm.
- Interpreter stop
- NC Start disable in this channel.
Modify machine data.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 frame: illegal switchover of geometry axes
%1 = Channel number
%2 = Block number, label
It is not allowed to change the geometry axis assignment because the current frame con-
tains rotations.
- Alarm display.
- Interface signals are set.
- NC Stop on alarm.
- Interpreter stop
- NC Start disable in this channel.
Change NC program or set other mode with $MN_FRAME_GEOAX_CHANGE_MODE.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 frame: type conflict
%1 = Channel number
%2 = Block number, label
It is not possible to chain global frames and channel-specific frames. The alarm occurs if a
global frame is programmed with a channel axis name and no machine axis on this NCU
is assigned to the channel axis.
Channel-specific frames cannot be programmed with machine axis names if there is no
corresponding channel axis on this NCU.
1 Alarms
1-275