Siemens SINUMERIK 840D Series Diagnostics Manual page 341

11.02
Reactions:
Remedy:
Program Continuation:
26101
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
26102
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
26105
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- NC Stop on alarm.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Restart drive, check drive software.
Switch control OFF - ON.
Axis %1 drive %2 communication failure
%1 = Axis name, spindle number
%2 = Drive number
The drive is not communicating.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
- Axes of this channel must be re-referenced.
• Check the bus configuration.
• Check the interface (connector removed, option module inactive, etc.).
Clear alarm with the RESET key. Restart part program
Axis %1 drive %2 sign of life missing
%1 = Axis name, spindle number
%2 = Drive number
The sign-of-life cell is no longer being updated by the drive.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
- Axes of this channel must be re-referenced.
• Check the cycle settings.
• Increase the cycle time if necessary.
• Power-up the drive again.
• Check drive software.
Clear alarm with the RESET key. Restart part program
Drive of axis %1 not found
%1 = Axis name, spindle number
The drive configured for the specified axis could not be found. For example, a Profibus
slave was configured on the NC but is not contained in SDB1000.
1 Alarms
1-341