Siemens SINUMERIK 840D Series Diagnostics Manual page 402

1 Alarms
Reactions:
Remedy:
Program Continuation:
61606
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61607
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61608
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61609
Parameters:
Definitions:
1-402
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 contour processing error
%1 = Channel number
%2 = Block number, label
Error detected with the contour preparation This alarm is always issued in connection with
an NCK alarm 10930...10934, 15800 or 15810. Alarm triggered by following cycle:
CYCLE95.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 starting point incorrectly programmed
%1 = Channel number
%2 = Block number, label
The starting point reached before the cycle call does not lie outside the rectangle
described by the contour subroutine. Alarm triggered by following cycle: CYCLE95.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 wrong cutting edge position programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE94, CYCLE96.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
A cutting edge position 1...4, matching the undercut form, must be programmed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 form incorrectly defined
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE94, CYCLE96.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02