Siemens SINUMERIK 840D Series Diagnostics Manual page 307

11.02
Definitions:
Reactions:
Remedy:
Program Continuation:
21800
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
The number of programmed auxiliary functions has exceeded the maximum permissible
amount. This alarm can occur in conjunction with motion synchronous actions: The maxi-
mum number of auxiliary functions must not be exceeded in motion block and motion syn-
chronous actions.
- Alarm display.
- Interface signals are set.
- NC Stop on alarm.
- Interpreter stop
- NC Start disable in this channel.
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 workpiece setpoint %2 reached
%1 = Channel number
%2 = Workpiece setpoint
This alarm is activated via MD 27880 PART_COUNTER, bit 1:
The number of counted workpieces ($AC_ACTUAL_PARTS or $AC_SPECIAL_PARTS)
is equal or already larger than the programmed value for the number of required work-
pieces ($AC_REQUIRED_PARTS).
At the same time, the channel VDI signal "Workpiece setpoint reached" is output.
The value for the number of the counted workpieces ($AC_ACTUAL_PARTS) is reset
while the value of $AC_SPECIAL_PARTS remains.
- Alarm display.
- Interface signals are set.
- NC not ready.
No program interrupt. Delete alarm display.
Clear alarm with the Delete key or NC START.
Channel %1 block %3 spindle %2 change of gear stage not possible
%1 = Channel number
%2 = Spindle number
%3 = Block number, label
Automatic gear stage selection has been programmed with M40. The new M word is not
in the present gear stage, but the spindle is not in "Open-loop control mode".
For automatic gear stage change (M40 in conjunction with spindle speed in address S)
the spindle must be in "Open-loop control mode".
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- If the axis is a single axis when this alarm is triggered, the alarm is only effective for this
axis (not effective for e.g. the channel or mode group)
Before the S word which requires a gear stage change, change into the open-loop control
mode of the spindle.
Change to the open-loop control mode is carried out with:
• M03, M04, M05 or M41 ... M45 from axis mode and positioning mode
• Interface signal "Gear is changed" (DB 31 - 48, DBX 16.3) from oscillation mode
Clear alarm with the RESET key. Restart part program
1 Alarms
1-307