Siemens SINUMERIK 840D Series Diagnostics Manual page 185

11.02
14290
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14300
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14310
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14400
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 polynominal degree greater than 5 programmed for polynom-
inal interpolation
%1 = Channel number
%2 = Block number, label
A polynominal degree greater than five was programmed for the polynominal interpola-
tion. You can only program polynomials up to the 5th degree.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 overlaid handwheel motion activated incorrectly
%1 = Channel number
%2 = Block number, label
Handwheel override has been called up incorrectly:
• 1. For positioning axes:
• Handwheel override programmed for indexing axes,
• No position programmed,
• FA and FDA programmed for the same axis in the block.
• 2. For contouring axes:
• No position programmed,
• G60 not active,
• 1. 1st G group incorrect (only G01 to CIP).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Handwheel %1 configuration incorrect or inactive
%1 = Handwheel number
• The inputs are using a drive with a drive number that does not exist or
• an inactive drive for assignment of the handwheel
(ENC_HANDWHEEL_MODULE_NR) or
• an axis is using a measuring circuit which does not exist for the drive hardware.
- NC Start disable in this channel.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. Check input configuration
(machine data) and/or drive hardware. Power-up is interrupted.
Switch control OFF - ON.
Channel %1 block %2 tool radius compensation active at transformation switcho-
ver
%1 = Channel number
%2 = Block number, label
A change of transformation is not allowed when tool radius compensation is active.
1 Alarms
1-185