Fujitsu Eternus DX100 S3 User Manual page 120

Chapter 3 Configuration Settings and Display
3.2 Volume Management > create volume
-type This parameter specifies the volume type.
open A Standard volume. A created "open" type volume is displayed as a "standard"
volume.
standard A normal/open volume (Standard)
sdv A Snap Data Volume (SDV) for Advanced Copy functions
sdpv A Snap Data Pool Volume (SDPV) for Advanced Copy functions
tpv A Thin Provisioning Volume
wsv A Wide Striping Volume
nas-tpv A Thin Provisioning Volume for a NAS (not supported in the ETERNUS DX200F)
nas-tpv-backup
A backup destination Thin Provisioning volume for NAS (not supported in the
ETERNUS DX200F)
If a malfunction occurs while creating a NAS volume (a Thin Provisioning Volume for a NAS or
a backup destination Thin Provisioning volume for NAS), or if the NAS volume was not created
normally, the following procedures must be performed to resolve the issue.
• After the system status and the NAS engine status becomes normal, delete the volume (a
Thin Provisioning Volume for a NAS or a backup destination Thin Provisioning volume for
NAS). System volumes do not need to be deleted. After that, create the volume again.
Using the "show volume" command, check the progress status (NAS Volume Format
Status) of the NAS system volume format. A completion status is displayed if the NAS vol-
ume is created normally.
Check the status of the NAS engine using the "show fru-ce" command.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
120
P2X0-1210-05ENZ0