Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set sas-parameters
-reset-scope
-reserve-cancel
■
Example(s)
The following example disables Host Affinity Mode for SAS interface port#0 on CM#1 CA#0 :
CLI> set sas-parameters -port 100 -host-affinity disable
The following example sets the initiator LUN as the reset scope for SAS interface port #0 on CM#0 CA#1:
CLI> set sas-parameter -port 010 -reset-scope initiator-lun
Optional. This parameter specifies the range of reset action. If omitted, the existing setting is
not changed.
initiator-lun Reset (Cancel) the command request from the server that sent the command
reset request.
target-lun
Reset (Cancel) the command request from all servers that are connected to the
port (regardless of whether the LUN is recognized).
Optional. This parameter specifies whether or not reservations are canceled when a host
interface port is reset. If omitted, the existing setting is not changed.
enable
Reservations are canceled.
disable
Reservations are not canceled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
233
P2X0-1210-05ENZ0