Show Subsystem-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 6 Information Settings and Display
6.4 Utility > show subsystem-parameters

show subsystem-parameters

This command displays the subsystem parameters.
■
Syntax
show subsystem-parameters
■ Parameter
No parameters.
■ Output
Load Balance
Reject INQUIRY from Unauthorized Host
Thin Provisioning Allocation Mode
Checkcode Enforcement Mode
Copybackless
Ignore CM-CM Communication Errors
Turbo Mode Indicates whether the Turbo mode is enabled.
Writeback Limit Count
■ Example(s)
The following example displays the subsystem parameters:
CLI> show subsystem-parameters
Load Balance
Reject INQUIRY from Unauthorized Host
Thin Provisioning Allocation Mode
Checkcode Enforcement Mode
Copybackless
Ignore CM-CM Communication Errors
Turbo Mode
Writeback Limit Count
Indicates whether controlling load balance of the system is enabled.
Indicates whether an INQUIRY command that is issued from an unauthorized host is accepted.
(When an INQUIRY command is set to be not accepted, the operation is the same as the
response to an INQUIRY command with an Affinity Error.)
Indicates whether the current setting of the Thin Provisioning Allocation mode is enabled.
Indicates whether the current setting of the Checkcode Enforcement Mode is enabled.
Indicates whether the Copybackless function is enabled.
Indicates whether ignoring communication errors between CMs is enabled.
Writeback Limit Count. This value is the number of process commands that are issued during
Writeback (writes data back to the drive).
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
[Disable ]
[Enable ]
[TPP balancing]
[Enable ]
[Enable ]
[Disable ]
[Disable ]
[ 512]
718
P2X0-1210-05ENZ0