Fujitsu Eternus DX100 S3 User Manual page 519

Chapter 5 System Settings and Display
5.2 Network Management > create snmp-view
-include-subtree
-exclude-subtree
■ Example(s)
The following example creates the MIB view named "1.3". It includes one sub-tree named "1.3.6.1.2.1" in the
MIB view.
CLI> create snmp-view -view xview4 -subtree1 1.3.6.1.2.1 -include-subtree 1
The following example is specified without the "-subtree2" parameter when "-subtree1", "-subtree3", "-
include-subtree1", and "-exclude-subtree3" are specified:
CLI> create snmp-view -view xview5 -subtree1 1.3.6.1.2.1 -subtree3 1.3.6.1.2.2 -include-subtree 1 -exclude-
subtree 3
Optional. This parameter specifies the "include" subtree type. A value between 1 and 10 can be
specified for the subtree number. Two or more subtree numbers can be specified by separating
them with a comma (,) or a hyphen (-).
If this parameter and the "-exclude-subtree" parameter are omitted, "include" is used as the
default for subtree.
The "-include-subtree" and "-exclude-subtree" parameters cannot both be specified for the
same subtree.
subtree_numbers
"Include" type subtree number (1 – 10)
Optional. This parameter specifies the "exclude" subtree type. A value between 1 and 10 can
be specified for the subtree number. Two or more subtree numbers can be specified by sepa-
rating them with a comma (,) or a hyphen (-).
If this parameter and the "-include-subtree" parameter are omitted, "include" is used as the
default for subtree.
subtree_numbers
"Exclude" type subtree number (1 – 10)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
519
P2X0-1210-05ENZ0